Downloaded from https://www.everyspec.com -RI 76-lg7 system, they will constitute for some period J of time the moat likely source of systmi fail- ure. 10-3.2 MULTIPLE LINE REDUNDANCY Multiple line rudundancy has been studied extensively by WeAnghouse and is one of the most efficient types of circuit redundancy (Refs. 6 and 7). It is applied by replacing the single circuit of a nonredundant network by nonadentacal xcwuts operating in parallel, FIGURE 10-1?. Ord.r hviwftpk Line where m i called the order of the redun- Reodwn Net wrk' danc. The reliability improvement achieved by these reduuidant circuits depends on the abil- ity of the network to experience circuit fail- d.
When all the circuits in the system ures without degradation of the network fail, the system fails. The system shown in operation. The use of restore.-s within the net- Fig. 10-12 is an example of a coherent work provides this characteristic. The restorer system. consists of m restoring circuits which, when The lower bound to system reliability is operating cxrectly, can de-ive the correct the probability that none of the system mini- output from k of m correct inputs. A typical mal cuts fail: for the sample in Fig. 10-12, it is circuit is shown in Fig. 10-11. A reliability model can be developed R, - (1 - Q 1 Q 2 )(1 - Q4Qs)(1 - Q 2 Q 3 Q 4 ) based on the following assumptions: (10-27) 1.
The circuits in the network are s-inde- where pendent. R, = system reliability 2. Only an approximation to the exact Q, = the probability of failure for circuit i. reliability will be given, and it is based on This equation is approximate because the fail- techniques described in Refs. 8 and 9. The ures of minimal cuts are assumed to be s-inde- approximation is good if the reliabilities of pendent which is generally not true, since one the circuits in the network are close enough component may appear in several minimal to one. cuts. 3. The approximation is based on the If minimal cut j is dtmoted by sei Sj then concepts of minimal cuts, discussed previous- T ly, and coherent systems.
A system is coher- 11 Qj is the probability of failure for minimal ent if it meets the following four conditions: ,tsj a. If a group of circuits in the system 6 failed, causing the system to fail, the occur- rence of any additional failure or failures will not return the system tc a successful condi- tion. h. If a group of circuits in the system is successful and the sys tem is successful, the system will not fail ii some of the failed components are returned to the successful condition. c. When all the circuits in the system are successful, thte system is successful. FIGURE 10.12. A Coherent System' 10-11