US Army Materiel Command AMCP 706-197 — AMCP 706-197 Reliability Prediction Handbook — US Army Engineering Design Guide PDF

Downloaded from https://www.everyspec.com - "11-17 cut j. Th- 'wer bound of the sytem reli- The lower limit approximation given for ability is the multiple line network is not good if the circuit refiabilities are not close enough to n -I Q( 2) one. If the order of the redundancy exceeds i. 1 i-"S three, the determination of the inaput sources becomes quite difficult. Boolean techniques crn be used for determining the input sources * c = number of minimal cut sets of a function. E = "is a member or. Thus, the determination of the lower bound 10-3.3 GATE-CONNECTOR REDUN. on reliability requires that the minimal cuts of DANCY the network be identified.

In a multiple line network with restorers, a cut is any group of Gate-onnector, or gate-connected. redun- circuits whose failure causes the outputs of at dancy is a combiration of several binary cir- least one restored function to have (m - k + cuits connected in parallel along with a circuit I) or more failed lines. This would constitute of switch-like gates which serves as the con- a retwork failure. necting majority organ (Refs. ! and 10). The The minimal cuts of a multiple line redun- gates contain no components whose failure dant network have three characteristics that would cause the redundant circuit to fail, and are sufficient to establish their identity:

any component failures in the gate connector 1. All the members of the minimal cut act as though the binary circuits were at fault. are circuits in a restored function or restorers Gate-connector redundancy applied to that are the input sources of that restor,.d four units in parallel and a 4-element network function. for the gate connector is shown in Fig. 10-13. 2. The failure of each member of the minimal cut will cause one output line of the restored function to be in error, and each member will be in a different position. One rout. s Outu 3.

The failure of a minimal cut will causeI ; Ou t exactly (m - k + 1) -output lines of the re- , stored function to be in error; hence, a mini- mal cut will have (m - k + 1)-members. g If all the sets of circuits that fulfill these inputs 3 characteristics are listed for each of the re- f stored functions in the network, all of the F 2 02 minimal cuts of the network and the lower f bound for the network reliability can be 4 found. gio.,mt The improvem'ntt in system reliability is comparable to the ;mprovement in the reli- FIGURE 10.13. Circuit IIlmtrttino Gaftconnector ability of a circuit when a particular element Retkmdafcyl is made redundant.

The improvement will not be of the same magnitude, because of the For this circuit, the following assumptions and nomenclature are used. addition of restorers in the multiple line net- work. 1. f = probability of failure for each binary unit Multiple line redundancy results in im- 2. g = probability of failure for each gate proved reliability of the system unless the 3. Failures are s-independent individual circuit reliabilities are very low. 4. If the circuit is closed when it should Low circuit reliabilities cause the restorers to be open, it is a Type I failure choose the wrong value if k of the m circuits 5. If the circuit is open when it should have failed.

be close' it is a Type II failure. 10-12