Downloaded from https://www.everyspec.com AMCP 70-197 j CHAPTER 9 RELIABILITY PREDICTION (TIME DEPENDENT) 9-0 LIST OF SYMBOLS and repair rates) are assumed to be constant. Any other assumption causes many complica- csqf(x 2 , P) = chi square Cdf with v degrees tion in the analysis. of freedom csqfC (x 2 , v) = 1-cqf(x 2 , V) 9-2 MEASURES OF RELIABILITY f(t) = pdfoft f(t), g(t) = pdf's for elements in par. 9-6 The two measures most frequently used S= pdf for element a in par. 9-7 to compare the effectiveness of redundancy F = Cdf for element a in par. 9-7 are: O(t), 47(t = Sf's for elements in par. 96 1. Mean time to failure (MTF) of the 7 cx = Sf for element a in par.
9-7 system-useful when mission times are long gauf(.) = Cdf for s-normal (Gaussian) compared to the lives of elements. distribution 2. Probability of failure of the syetem- gaufc (.) = 1-gauf(.) useful when mission times are short compared k - xa' to the lives of elements. MTF i - Nean.Time to failure for case i In all cases in this volume, the proviso exists P, qi = element s-reliability and on all formulas that the indicated operation is s-unreliability, ,espectively, "legal" and the result exists. The proviso is (Table 9-2) satisfied for practical reliability problems.
pdf = probability density function The MTF is defined as R(t), Rjt) - a-reliability ding interval 0 MTF =fo ( to t M fTF t) dt (tmdt (9-1) 6. = s-reliability for case i where 1-?i a- denotes statistical definition f(t) = pdf of time to failure Sf = Survivor function R(t) = Sf of time to failure t = time, time 'to-failurp t = a time 0 t, t 9-3 THE EXPONENTIAL DISTRIBUTION z. = standard s-normal variate 0 :
an MTF for situation i The time-to-failure pdf and the reliability , x i = failure rates function (survivor function Sf) of the expo- = failure rates nential distribution are, respectively, Xt = dimensionless "parameter" ft) = Xe - t 9 p, u = mean and standard deviation, (9-2) respectively, for an s-normal R(t) = e - t distribution where X is the constart failurm (hazard) rate. r = Xt; time interval for paf. 9-9 All failures are s-independent and all standbys are hot (active). 9-1 INTRODUCTION 9 Iase 1. Two elements in parallel J-out, culating reliability of redundant systems.
s-reliability 6 1 (t) is There is a multitude of formulas for cal- of-2:G) have fe.ilure rates, X, and X b - The Virtually all of them presume conditional 6? 1 (t) = 1 - (1 - e- Nt)(1 - e -Xbt) s-independence of the elements. It is impor- =e--a" + e-X bt -e--(A+kb) t tant in i practical analysis to list each set of (9-3a) conditions under which s-independence will MTF 1 --- (9-3b) hold. MT \' = + 7b - k --- b In the vast majority of cases in analyses QgIgL. Same as Case 1, except X, = ., - for redtindancy, transition rates (eg., failure X (identical elements), then 9-1