Downloaded from https://www.everyspec.com Amu 7 M-107I al(t) ( - 2 - (- t1 9.4%) TAKE9-I1 I RATIOS OF MTFS FOR m ACTIVE-PARALLEL CmeS. m ative-pmilel elments (1-out- of-m:G, hot standby). m drF2 2h. (9-4b) ELEMENTS 2 9 3 (t) " (1- - ") 19 ) 1 1.00 - 5-1 2 U50 1.50 MTFI2 i+ 3 1.83 1.22 Q.1-1 I 4 2.08 1.14 m In(9-5b) 5 2.28 1.10 E - X&j+ A-k ... William H. Von Alvin, Ed., Rdiebilit Egineerin., 0 1964 i,j~k I by ARINC Reserch Corporation. Relxinted by lerNsoiion of Prentice-Hall. Inc., Englewood Cliffs, NJ. elements are identical, X, = X for all i. OI/8r -) '. f or m - 1,2,3,4,5; Case 4.
Same as Case 3, except all gives the ratios of MTF for 0I/0 and () m (where e 1 = MTF for i elements as given by Eq. 44(t) : e- ) (9-6a) 9-6b. ih ITF - I (9-6b) From Table 9-1 it can be seen that the 0 /mi I maximum occurs when m = 2. 9 E TMThe improvements are, in most cases, the 1RELIABILITY maximum that can be achieved. If the elements have more than one failure mode The reliability functions for a system with and/or if switching is imperfect, the m parallel (1 -out-of-m:G, hot standby) effectiveness of the redundancy is reduced. elements (m = 1,2,3,4,5) and X = Aj constant are plotted in Fig. 9-1.
9-3.2 REDUNDANCY VERSUS IMPROVED Another method of measuting reliability ELEMENTS improvement is to culculate the ratios (or differences) in MTF of two systgms. Tcble 9-1 A system designer may have the option of 1.0 .adding redundant elements or using improved &elements in a nonredundant configuration to increase reliability (Refs. 1 and 2). The designer must consider effectiveness, cost, 0.8- weight, maintenance, and other related 1 r considerations in making his choice. 0.6 fige . Two alike elements are connected 0.6 -in active-parallel (Case 2); their MTF is 3/(2X), from Eq. 9-4a.
To obtain the same 0.4 - * I--- M TF with a single improved element, the 0o.4- improved element must have X = 2 3. William H. Von Alvern, Ed., Roeiabiliz. Enqsneering. Q 1964 The s-reliability R 5 of the improved by AHINC Resparch Corpoation. Reprinind by permission element is = e- 't = e- 2Xt/I (9-7a) of Prentice-Hal', Inc., Englewood Ciffs, N.J. FIGUrtE 9.1. Reliability Function for Syster,,s With MTFj 1 (97b) m Idenrical, Act've. Parallel Lements, Each Wit, T ( The s-reliabilities iR and 6?5 are plotted in Cotislant Feiiie Rae -(out-of-mn:G) Q 49-2