Downloaded from https://www.everyspec.com Notation for Table 9-2: The MTF is computed by integrating the ps - srvival probability of element i reliability function: q,= 1-p, 5T 9 =' - MTF-E -F,-L 199.5- A - common constant failure rate - - 1 for last column. i-1 If the failure rates are neither common nor 132.9 = 66.6. (9-17) constant, the MTF is tedious and difficult to calculate. As an example, assume the 9-6 s-DEPENDENT FAILURE PROBABJL redundant system in Fig. 9-3.
System ITIES reliability can be determined frovn Ss (t)= e- [e- b t + e- t Up to this point, it has been assumed that the failure of an active redundant element has - e-(Ab+ Ac)] X e (-d+e)t no effect on the other active elements. However, the opposite condition often + e'- e-(Xd + e f). (9-14) arises-the failure of one element does affect s 9 the others. For example, consider the block e -E e-hidiagram in Fig. 9-4. A and B are both fully - (9-5) energized, and normally share or carry half the load-L/2. If either A or B fails, t;'e where survivor must then carry the full load. Hence, 1 + A'.
+ X, = 0.020 the probabilit) that one (say B) fails depends + X + X + X 0.022 on the state of the other if failure probability 2 b + d + is related to loal or stress. A simple example + +±A + Xe 0.027 would be a 2-engine airplane which, if one - + + = 0.025 engine fails, can still keen flying. However, 4 + X, + Xf + the survivirg engine now has to carry the full - + Xh + A' + d + e + lf load and has a higher probability of failing. 0.037 For this relatively simple example, the X + ? + A + X + ?f =0.027 re'aablity function can be derived by X - + + + A + X =0.032 co,'sidering all possible ways of system ' success, as shown in Fig. 9-5.
The bar above a s = X, + ' + , + , = 0.032 letter represents failure of that element. The X9 = f 0.030. (9-16) prime represents operation of that element °i E X8a 0.0100 Xў = 0.0100 Aeo 0.0033 Ab = 0.0050 X d = 0.0033 X f -0.0050 For convenience, the X has been taken as dimensionless. Actually, the MTF will have the reciprocal dimension of the X. William H. Von Alven, Ed., Reliability Engineering, (0 1964 by ARINC Research Corporation. Reprinted by permission of Prentice-Hall, Inc., Fnglewood Ciffs, NJ. FIGURE 9-3. Illustrative System2 9-7