US Army Materiel Command AMCP 706-197 — AMCP 706-197 Reliability Prediction Handbook — US Army Engineering Design Guide PDF

Downloaded from https://www.everyspec.com -M 70S-97 Tme axis ALoad L Cocl j Lo IL Condito.n 1 ) ,AB (2 AS BS Ulliar H. Von Aon. Ed.. M/itV' EPOMMM. V IN4 ( A- by ARu ~ Carpoamin Reprinted by permiinioi If A' of ftentice4bl, Inc.. Eng kood Cliffs, NJ. FIGURE 94. Systm With Load Dependent Failur 2 SucIS - Conditiom I). 12). or 13) under full load; absence of a prime represents FIGURE 9-5. Time Sequenmce Dieram 2 operation under half load. The derivation is as follows. Let f(t) = failure-time pdf of each element when both elements are operating; .

The element failure times are exponentially distributed and each has a P(t) = Sf correponding to f(t) parameter A, under load L/2, and X under load g(t) = element failure-time pdf of the un- L. Define failed element when one element k = X/,. (9-21) has failed; The solution of Eq. 9.20 is 0t) = Sf corresponding to g(t) R(t) = 12 exp (-Xt) - k exp (-2t)I/ t i = some point in time (2-k),k 0 2 (9-22) L = full load R(t) = (2Xt+1) exp (-2Xt), k = 2 (9-23) The system operates satisfactorily at time The system MTF is t if either A or B both are operating successfully. Under the assumption that the MTF =- + 1).

(9-24) elements are s-independent if both are X 2 operating, the prcbability that both will When k = 1, load-sharing is not present, operate until time t is i.e., increased load does not affect the element failure probability. This assumption [F'(t)]2 (9-18) was made in the previous discussions of active-parallel redundancy. If there were only the dfothr surviing e t faiung atLti/ e and one element, it would be operating under full the other surviving to under L/2 and from load; therefore, the system MTF would be 1/X I totunderLis = 1/(kX).

f(t 1 )F(t 1 )C(t-t 1 ) (9-19) A single improved element can be used as an alternative to redundancy when this Since t 1 can range from 0 to t, this pdf is s-dependent model is assumed. The effects of using improved single elements or redundant integrated over that range, and the resulting standard elements can he illustrated as probability is doubled because the event can follows. Consider occur in either of two ways. Hence, A: Single standard element; X 1/50 R(t) = I[F(t)1 2 + 2 f(t 1 ) B: Single improved element; ? 1/100 0 C: s-Depeitdent model, standard elements; N (half load) = 1/100, X'(full load) = F(t 1 )(t-t )dt 1 (9.20) 1/50. 9.8