US Army Materiel Command AMCP 706-197 — AMCP 706-197 Reliability Prediction Handbook — US Army Engineering Design Guide PDF

Downloaded from https://www.everyspec.com -M W ?WIW 9.7.1 SWITCHING FAILURES This equation represents a geni cae in that the following poulbilitim are included: Case The following notation will be 1. A and B can be different elements. used for a 2-element standby redundant unit requring a decision-and-switching device that 2. A static failure can occur f B is switches in one direction only (Rd. 2): energized, resulting in no output or a false indication of system failure. If a static failure (t), fl, (t) - failure pdr of elements A and cannot occur when B is energized, then P(t) B =1. fG(t) = failure pdf of element B when 3.

8 can fail while on standby, and its on standby failure pdf can be different from that when B f, (t) conditional contact failure pdf is enerized. If B is a "cold" rather than a (failure of the contact to "warm" or "hot" reserve, fg(t) 0, Pb(t) = 1. maintain a good connection, Caw I1. Same as Caw 10, but identical given that a good connection elements (A and B) writh constant failure rate initially existed) = A a = X and cold standby. Eq. 9-31 f (t) = conditional dynamic failure pdf becomes (failure to switch, given that A has failed) fil (t) = e Z A+ fz(t) = conditional static failure pdf (switching when not required) (1- eY t)]. (9-32) required) F., F.

= Cdf and Sf corresponding to f,, Ca.eJ. Same as Case 11, but a =a, b, ,xy,z = x =0. f(t), f (t), and f(t) refer to then, sin9. decision-and-switching device failures which te,_ may not be time-dependent. If these failures l[n I -- hy are not time-dependent, the appropriate X t failure pdf is replaced by a canstant probability of failure. I 1 1 (t) = F (t) ( IF t)p F t) + 5 F (t 1 ) R 1 2 (t) fe x'(1 + Xt). which agrees with Eq. 9-29b, as it should. The 0 effects of imperfect switching also are f(tI )F,(tt 1 )F'(t 1 )Fb(ttl )I analyzed in Refs. 4,6,7. dt f(t)(t)(t) 9-7.2 OPTIMUM DESIGN: GENERAL dt t2z2y2 MODEL Case 13.

There are n redundant paths F,(t 2 )'(tt 2 )Fb(tt)dt 2 with (n - 1) in cold standby, and each path Erequires a switching device. In this model, the In Eq. 9-31, the first term inside the brackets monitor represents the failure-detection and represents the probability that A operates to t switch ing-control functions. These two without premature switching. The second functions can be considered as one for term represents the probability that a static reliability purposes if it is assumed that the failure occurs at time t, t, but B operates to t. The last term represents the probability poality ofacompensatin s is thtAfis.ttm negligible.

All failure distributions have that A falls at time t t and the c nt n al r rt s 2 constant failure rates. decision-and-switching device switches to B (no dynamic failure), which operates to t. The following assumptions are made when 9-10