Downloaded from https://www.everyspec.com AMCP70-197 computing the reliability of these systems it eXP (-A. t) csqfc (2 dI + V) (Ref. 2): 13() 1. Switching is in one direction only. (9-351)) 2. Standby (reserve) paths cannot fail if where not energized. where 3. Switching devices ought to respond csqf(x,) = chi square Cdf with u only when directed to switch by the monitor; degrees of freedom false switching operation (static failure) is cSqfc(X 2 ,) = 1 - c8qf(X 2 ,v) = detected by the monitor as a path failure, and complement of the switching is initiated. csqf 4. Switching devices do not fail if not (named in analogy with the error function) energized. 5.
Monitor failure includes both dynamic and static failures. The monitor is a "series" The maximum reliability for a fixed r that element in the system. can be achieved, as n -* -, is exp(-Xm t). Define terms as Therefore, if A > A, (monitor is worse than A = total (sum) failure rate of the series an clement) the optimum design has 1 elements in a path element and no switching/monitoring. X = failure rate of the switching device Eq. 9-5 is a function of A/A, X., and r. (includes contact failure) The mission reliability of the redundant Xq = failure rate of the monitor system can be calculated as a function of the parameters in Eq. 9-35. Table 9-3 and Figs.
then, for n total paths, 9-8 and 9-9 show some of these calculations. ( = e mt e ( h f \,)t Table 9-3 shows how system reliability is S/einfluenced by the number of paths, if the S1 , (933) switching device and the monitor have failure X I . rates that are 1, 1/10, and 1/100 as great as ' the path failure rate. In Fig. 9-8 the reliability of the redundant To illustrate the reliability gain provided system is given as a function of the number of by this model, assume that the system paths for various ratios of AM /X when R1 3 (t) specificatioti requires a high reliability for a = 0.80; arbitrarily, X,/, = 1/1000. Fig. 9-9 is missior of t hours.
A nonredur.dant system similar except that Xm /A = 1/1000, and , /A therefore would have a reliability of varies. R 1 (t) = e ht, (9-34a) The following general conclusions . be drawn from this paragraph:, since no switching is required. The redundant 1. As the number of redundant paths system would have an s-reliability given by increases, the mission reliability approaches Eq. 9-33. the reliability of the monitor., R(t) =R 13 (t) (9-34b) 2. When the failure rates of the path, the switching devices, and the monitor are equal, Define r A- ,t and substitute for t in Eq. standby redundancy with two paths results in 9-33, except in the X,, term.
a mission reliability considerably less than that of a single nonredundant path. l3(T) exp(-Xmt)exp [-(1 + - j 3. For systems where the switching-device and monitor failure rates are n-1 less than the path failure rate, the greatest F X + "increase in reliability occurs when one ,= 0 (9-35a) redundant path is added to a single path. 9-11