EPSON — Necessary settings and procedures for color plate printing

Epson L-6034VW Operation Guide Various Print Settings Reverse White Printing Clear film is printed with color ink first followed by white ink using a printing method that allows you to view the results from the back of the film. You can use one of the following methods to perform reverse white printing. ❏ Rewind the substrate on which the color plate was printed, and then reload it on the unwinder side U “Replacing the Substrate and Performing Reverse White Printing” on page 141 ❏ Perform reverse feed by the amount of the color plate that was printed U “Performing Reverse Feed of the Substrate and Performing Reverse White Printing” on page 144 Note:

This reverse feeding method for the printed color section is useful for test prints or when the whole print job is short (100 m or less) However, this method cannot be used if the substrate is too flexible or it is a narrow-width film. Replacing the Substrate and Performing Reverse White Printing The following outlines the workflow.

❏ Print the color plate using the reverse feeding function for substrate with eye marks ❏ Remove the substrate on which the color plate was printed, and load on the unwinder side ❏ Use the additional printing function to print the white over the color Necessary settings and procedures for color plate printing A Set additional printing for color plate in a preset suitable to the type of substrate loaded, and set it as the default preset. See the following for more information on creating presets. U “Creating and Editing Preset” on page 114 Lead Out is the necessary margin left before the print start position when printing the white plate.

Also, Lead In is the margin after the last page when printing the white plate. When the Lead In is set to 16 m or more in the preset settings, you can print to the final page when printing the white plate. 141 Item Value Lead In 16m or more Lead Out 24m Print Method For Reverse White Jobs Color Plate Printing