EPSON — Necessary settings and procedures for color plate printing

Epson L-6034VW Operation Guide Various Print Settings U “Preparing to Wind up the Substrate” on page 65 U “Loading Procedure for the Substrate” on page 33 U “Settings for the replacement substrate/feeding the substrate” on page 48 steps 1 to 8 H Press Adjust Eye Mark Sensor on the Loaded Substrate tab from the Substrate Settings menu to perform eye mark detection and adjust the sensitivity of the eye mark sensor. Adjust the eye mark sensor to the eye mark at the point where printing starts.

U “Eye mark detection and sensor sensitivity settings during additional printing” on page 55 I Press Adjust Print Position on the Loaded Substrate tab, and then set Adjust Print Position Horizontally and Adjust Print Position Vertically to 0. J Return to the Operation Status screen, move the press switch from Standby to Ready , and then start printing. Print the first copy, and then pause on the unwinder side workbench. K Check the print results and measure the print shift in the color and white plates, and then enter the horizontal and vertical shift values in Adjust Print Position Horizontally and Adjust Print Position Vertically as the adjustment values. L Press Print .

M On the screen displayed, enter the number of copies, and then press Print . Start white plate printing. This completes this section. Performing Reverse Feed of the Substrate and Performing Reverse White Printing This section explains how to perform reverse feed of the substrate that has been printed on, and then perform reverse white printing without changing the substrate by using the reverse feeding and additional printing functions. The following outlines the workflow.

❏ Print the color plate using the reverse feeding function for substrate with eye marks ❏ Perform reverse feed by the amount of the color plate that was printed ❏ Use the additional printing function to print the white over the color Necessary settings and procedures for color plate printing A Set additional printing for color plate in a preset suitable to the type of substrate loaded, and set it as the default preset. 144 Item Value Stop Position After Print Rewinder Side Workbench