Epson L-6034VW Operation Guide Various Print Settings R Select the substrate color and the eye mark color, and then set the eye mark sensor lever position. U “Settings for the replacement substrate/feeding the substrate” on page 48 steps 11 to 16 S Return to the Operation Status screen, move the press switch from Standby to Ready , and then start printing. U “Adjusting the Print Position Using a Ruler” on page 132 steps 6 to 10 T Press Print . U On the screen displayed, enter the number of copies, and then press Print . Start surface printing. Next, print the rear surface. Proceed to the next item.
Necessary settings and procedures for rear surface printing Follow the print procedure for surface printing. A Set additional printing for rear surface printing in a preset suitable to the type of substrate loaded, and set it as the default preset. See the following for more information on creating presets. U “Creating and Editing Preset” on page 114 U “Creating and Editing Print Info.” on page 117 B Check that the press switch is set to the Standby position. C Perform printing from the print software, and then check that the rear surface print data for this print job was received on the touch panel. D Select the print job from the Job Management menu, and then press Print Settings .
151 Item Value Additional Printing Apply Eye Mark Horizontal Offset Set the distance from the right edge of the eye mark to the right edge of the print data. See the following when setting a value of more than 500.0 mm. U “Settings when the Eye Mark Offset Exceeds 500 mm” on page 139 Eye Mark Pitch Enter the print data width for surface printing Eye Mark Sensor Position Bottom Lead In 0m Lead Out 0m