EPSON — Necessary settings and procedures for rear surface printing

Epson L-6034VW Operation Guide Various Print Settings P Press Continue without setting the items on the screen. Press Finish on the next screen. Finish replacing the substrate here as the next step is to adjust the sensitivity for eye mark detection and the eye mark sensor. Q To align the print start position with the rear position, move the lead eye mark on the printed surface to the position just before the eye mark sensor. (1) Open the Feed Subst tab from the Substrate Settings menu. (2) Set the Feeding Amount to "15.9m", and then press Start feed . The leading eye mark stops at the cutting position on the unwinder side workbench. Press the Slow Feed or Slow Rev.

Feed switch as necessary to align the leading eye mark with the cutting position. (3) Set the Feeding Amount to "0.7m", and then press Start feed . The leading eye mark stops just before the eye mark sensor. R From Adjust Eye Mark Sensor on the Loaded Substrate tab, adjust the sensitivity for eye mark detection and the eye mark sensor. U “Eye mark detection and sensor sensitivity settings during additional printing” on page 55 S Press Adjust Print Position on the Loaded Substrate tab, and then set Adjust Print Position Horizontally and Adjust Print Position Vertically to 0. T Return to the Operation Status screen, move the press switch from Standby to Ready , and then start printing.

Print the first copy, and then pause on the unwinder side workbench. U Check the print results and measure the print shift in the surface and rear surface, and then enter the horizontal and vertical shift values in Adjust Print Position Horizontally and Adjust Print Position Vertically as the adjustment values. V Press Print . W On the screen displayed, enter the number of copies, and then press Print . Start rear surface printing. This completes this section. 153