Epson L-6034VW Operation Guide Introduction 18 Caution Do not push the carriage unit or the light shield inside the press. This could cause the press to malfunction or breakdown. a. Main unit front b. Main unit rear Before using the corona treater, make sure there are no foreign substances such as scraps of paper or dust on the corona discharge section. If corona discharge is performed when foreign substances such as scraps of paper or dust are stuck to the surface, smoke could be emitted or fire could ignite. Make sure you remove any foreign substances such as scraps of paper or dust from the corona discharge section.
When a paper jam occurs, check that the blower for the corona treater has stopped, and make sure that no substrate or scraps of paper are touching the corona discharge section. If any scraps remain, make sure you remove them. If corona discharge is performed when scraps of paper remain, smoke could be emitted or fire could ignite. Fire does not ignite while the blower is operating. If an error causes the press to stop, corona discharge is stopped immediately.
If you notice any feeding abnormalities such as a paper jam and so on, cancel the print job, check that the blower for the corona treater has stopped, and make sure that no substrate or scraps of paper are touching the corona discharge section. If any scraps remain, make sure you remove them.