Epson L-6034VW Operation Guide FAQ Changing the tension value ❏ When replacing the substrate Change the tension setting in the Substrate Settings menu - Change Substrate step 2. ❏ After changing the substrate (when telescoping or an error occurs) Change the tension setting in the Substrate Settings menu - Change settings screen. The print position shifts when replacing with the same type of substrate during a print job A. If a roll end error occurs during a print job, the print position shifts when replacing the substrate from the Change Substrate screen. Follow the steps below without pressing change substrate on the Change Substrate screen.
A Press the Feed Ready switch on the press to release the tension in the substrate. B See steps 8 to 22 in “Replacing the unwinder side substrate” on page 34 to replace the substrate. c Important: ❏ The print position shifts when you replace the substrate from the Change Substrate screen. Do not press Change Substrate on the Substrate Settings menu. ❏ Do not move the paper edge sensor. C Follow the instructions in the error message to clear the error. D Press the Start switch to restart printing. 230 Problem What to do "E-9" is displayed on the display of the corona treater control panel A corona roller is not rotating. See the following to raise the tension value for unwinding.
❏ When the value is below the standard value: Return to the standard value ❏ When the value is higher than the standard value: Increase by 5 N more than the current value Press the OFF switch on the corona treater control panel to cancel the error display on the corona treater control panel.