Џ The adjusting screw which holds the roll paper near-end detector, may be loosened and then set the top of “B” to the adjustment value found in Ћ , and tighten the adjusting screw. (The adjusting screw can be turned with a coin.) Screw ђ Be sure that the detecting lever operates smoothly after finishing the adjust- ment. l Since the adjustment values in Table 3-1 are calculated from standard NOTES: * If a roll paper with a red end mark at the paper end is used, this mark may cause the paper to stick together. If this occurs, the dimension A differs from the table. measurements, there may be some variations depending on the model.
- Be sure that the detecting lever operates smoothly after finishing the adjustment. * If the roll paper becomes loose due to poor paper quality, the detector may operate incorrectly. 18