EPSON — Error Indicators

User’s Guide Error Indicators 93 Light Situation Solution An unsupported device is connected to the external interface USB port. Connect a device, such as a digital camera that supports PictBridge, to the external interface USB port. A USB hub is connected to the external interface USB port. The external interface USB port does not support USB hubs. Connect a USB cable directly. The device connected to the external interface USB port is not responding. Connect device, such as a digital camera that supports PictBridge, to the external interface USB port. Check that the connected device is operating normally, such as the battery power.

A USB cable is connected to the external interface USB port when connecting PictBridge over a network. Remove the USB cable from the external interface USB port. An error has occurred when connecting to a Wi-Fi network. Note the following points to set up a Wi-Fi network again. ❏ Set the Wi-Fi access point to Wi-Fi setup mode. ❏ Shorten the distance between the Wi-Fi access point and the printer to within 3 meters, and then try again. A security error occurred when connecting to a Wi-Fi network. Another Wi-Fi network device may be connecting to the Wi-Fi network at the same time. Try again later. A printer error has occurred.

Turn off the printer, check that there is no paper jammed inside the printer, and then turn it back on. If the error is not cleared, contact Epson support. & “Paper Jams” on page 97 & “Contacting Epson Support” on page 117 The firmware update failed (recovery mode). Follow the steps below to try to update the firmware again. 1. Connect the computer to the printer with a USB cable. 2. Visit your local Epson website to download the latest firmware and start installing. See the instructions on the download page for more details.