EPSON — Messages and Solutions on the Network Connection Report

Network Guide Solving Problems 78 Code Message Solution E-2 No wireless network names (SSID) found. Confrim that the router/access point is turned on and the wireless network (SSID) is set up correctly. Contact your network administrator for assistance. ❏ Make sure that the access point is turned on. ❏ Check that the computer or other devices are connected correctly to the access point. ❏ Place the printer close to the access point. Remove any obstacles between them. ❏ If you have entered the SSID manually, check if it is correct. Check the SSID from the network status screen on the printer's control panel or the network status sheet.

❏ To establish a network using Push Button Setup (WPS), check that the access point supports WPS. If it does not support WPS, you cannot establish a network using Push Button Setup (WPS). ❏ If you want to connect the printer and a computer in Ad Hoc mode, set up your computer in Ad Hoc mode and start a connection, and then make the printer's network settings. ❏ Check that only ASCII characters (alphanumeric characters and symbols) are used for the SSID. The printer cannot display an SSID which contains any characters other than ASCII characters. E-3 No wireless network names (SSID) found. Confrim that the wireless network name (SSID) of the PC you wish to connect is set up correctly.

Contact your network administrator for assistance. ❏ To establish a connection in Ad Hoc mode, make sure the computer is turned on. If it is turned off, turn it on and then make the printer's network settings. ❏ Place the computer close to the printer. E-4 Wi-Fi communication mode (IEEE802.11b/g/n) does not match the current setting of the printer. Set the same communication mode to the printer, router/access point, and PC. Contact your network administrator for assistance. Make sure the Wi-Fi standard set on the access point matches the printer's Wi-Fi standard. See the User's Guide for the printer's Wi-Fi standards.

If the standard does not match, adjust the Wi-Fi standard on the access point. See the documentation provided with the access point for details. E-5 Security mode (e.g. WEP, WPA) does not match the current setting of the printer. Confrim security mode. Contact your network administrator for assistance. Make sure the access point's security type is set to one of the following. If it is not, change the security type on the access point, and then reset the printer's network settings. ❏ WEP-64 bit (40 bit) ❏ WEP-128 bit (104 bit) ❏ WPA PSK (TKIP/AES)* ❏ WPA2 PSK (TKIP/AES)* ❏ WPA (TKIP/AES) ❏ WPA2 (TKIP/AES) * : WPA PSK is also known as WPA Personal. WPA2 PSK is also known as WPA2 Personal.