EPSON — Messages and Solutions on the Network Connection Report

Network Guide Solving Problems 79 Code Message Solution E-6 MAC address of your printer may be filtered. Check whether your router/ access point has restrictions such as MAC address flitering. See the documentation of the router/access point or contact your network administrator for assistance. ❏ Check if the MAC address is disabled. If it is enabled, register the printer's MAC address so that it is not filtered. See the documentation provided with the access point for details. You can check the printer's MAC address from the network status screen on the printer's control panel or by printing a network status sheet.

❏ If the access point's shared authentication is enabled on the WEP security method, make sure the authentication key and index are correct. E-7 Entered security key/password does not match the one set for your router/ access point. Confirm security key/ password. Contact your network administrator for assistance. ❏ The password set on the access point and the entered password do not match. The password is case sensitive. Enter the correct password. ❏ If the Wi-Fi connection is suddenly disconnected, check the following. If any of these are applicable, reset the network settings using the software disc supplied or using the software downloaded from the website.

http://epson.sn ❏ Another Wi-Fi device was added to the network using Push Button Setup (WPS). ❏ The Wi-Fi network was set up using any method other than Push Button Setup (WPS) from the software disc supplied. E-8 Incorrect IP address is assigned to the printer. Confirm IP address setup of the network device (hub, router, or access point). Contact your network administrator for assistance. ❏ Enable DHCP on the access point when the printer's Obtain IP Address is set to Auto. ❏ If the printer's Obtain IP Address is set to Manual, the IP address you manually set is out of range (for example: 0.0.0.0) and it is disabled. Set a valid IP address.

E-9 Confrim the connection and network setup of the PC or other device. Connection using the EpsonNet Setup is available. Contact your network administrator for assistance. Check the following. ❏ Devices are turned on. ❏ You can access the Internet and other computers or network devices on the same network from the devices you want to connect to the printer. If it still does not work after checking the above, reset the network settings using the software disc supplied or using the software downloaded from the website. http://epson.sn E-10 Confrim IP address, subnet mask, and default gateway setup. Connection using the EpsonNet Setup is available.

Contact your network administrator for assistance. Check the following. ❏ Other devices on the network are turned on. ❏ Network addresses (IP address, subnet mask, and default gateway) are correct if you have set the printer's Obtain IP Address to Manual. Reset the network address if these are incorrect. You can check the IP address, subnet mask, and default gateway from the network status screen on the printer's control panel or by printing a network status sheet. When DHCP is enabled, change the printer's Obtain IP Address to Auto. If you want to set the IP address manually, check the access point's IP address, and then select Manual on the printer's control panel.

Set the subnet mask to [255.255.255.0].