Network Guide Solving Problems b. Messages on the Network Environment 80 Code Message Solution E-11 Setup is incomplete. Confrim default gateway setup. Connection using the EpsonNet Setup is available. Contact your network administrator for assistance. Check the following. ❏ The default gateway address is correct when you set the printer's TCP/IP Setup to Manual. ❏ The device that is set as the default gateway is turned on. Set the correct default gateway address. You can check the default gateway address from the network status screen on the printer's control panel or by printing a network status sheet. E-12 Confrim the following:
❏ Entered security key/password is correct ❏ Index of the security key/password is set to the frist number ❏ IP address, subnet mask, or default gateway setup is correct Contact your network administrator for assistance. Check the following. ❏ Other devices on the network are turned on. ❏ The network addresses (IP address, subnet mask, and default gateway) are correct if you are entering them manually. ❏ The network addresses for other devices (subnet mask and default gateway) are the same. ❏ The IP address does not confilct with other devices. If it still does not work after checking the above, try the following.
❏ Make network settings on the computer that is on the same network as the printer using the software disc supplied or using the software downloaded from the website. http://epson.sn ❏ You can register several passwords on an access point that uses the WEP security type. If several passwords are registered, check if the frist registered password is set on the printer. E-13 Confrim the following: ❏ Entered security key/password is correct ❏ Index of the security key/password is set to the frist number ❏ Connection and network setup of the PC or other device is correct Contact your network administrator for assistance. Check the following.
❏ Network devices such as an access point, hub, and router are turned on. ❏ The TCP/IP Setup for network devices has not been set up manually. (If the printer's TCP/IP Setup is set automatically while the TCP/IP Setup for other network devices is performed manually, the printer's network may difef r from the network for other devices.) If it still does not work after checking the above, try the following. ❏ Make network settings on the computer that is on the same network as the printer using the software disc supplied or using the software downloaded from the website. http://epson.sn ❏ You can register several passwords on an access point that uses the WEP security type.
If several passwords are registered, check if the frist registered password is set on the printer. Message Solution *Multiple network names (SSID) that match your entered network name (SSID) have been detected. Confrim network name (SSID). The same SSID may be set on several access points. Check the settings on the access points, and change the SSID.