Network Guide Solving Problems Checking the Connection Using a Ping Command Checking the Connection Using a Ping Command - Windows 1. Check the printer's IP address for the connection that you want to check. You can check this from the Network Status screen on the printer's control panel, a connection report, or the [IP Address] column of a network status sheet. 2. Display the computer's command prompt screen. ❏ Windows 8.1/Windows 8 Display the application screen, and then select Command Prompt . ❏ Windows 7 or earlier Click the start button, select All Programs or Programs > Accessories > Command Prompt . 3. Enter ‘ping xxx.xxx.xxx.xxx', and then press the Enter key.
Enter the printer's IP address for xxx.xxx.xxx.xxx. 81 Message Solution *Signal strength is low. If you have problems printing or scanning, improve your wireless network environment. The printing speed may be slow or printing may stop due to medium signal strength. Placing the printer close to the access point, or removing any obstacles between the access point and the printer may improve the environment. *A router/access point channel confilct has been detected. If you have problems printing or scanning, improve your wireless network environment. Signal interference can be caused by other wireless networks being used in nearby rooms or buildings.
Placing the printer close to the access point, or changing the access point channel setting may improve the environment. See the documentation provided with the access point for details. *Signal strength is low. A router/access point channel conflict has been detected. If you have problems printing or scanning, improve your wireless network environment. The printing speed may be slow or printing may stop due to low signal strength. Signal interference can be caused by other wireless networks being used in nearby rooms or buildings. Placing the printer close to the access point, or changing the access point channel setting may improve the environment.
See the documentation provided with the access point for details. *No more devices can be connected. Disconnect one of the connected devices if you want to add another one. You can simultaneously connect up to four Wi-Fi devices in Simple AP mode. To add another Wi-Fi device, disconnect one of the connected Wi-Fi devices first.