5.3 Controlling buzzers, pausing, and cutting This section describes the control method for instructing the printer to sound a buzzer, make a cut, or pause after the desired label is printed. Send an instruction for the buzzer each time a label is printed (^XA-^XZ). Send an instruction to pause the printer by using the ^PQ command or the ^PP command each time a label is printed (^XA-^XZ). ^PQ Pause printer each time the specified number of labels is printed ^PP Pause printer after the last label is printed For cutting, use the ^S(C command to set the printer to make a cut. The last label will always be cut.
However, use the ^PQ command to set the cut timing when selecting whether to make a cut after each page. Examples of command parameters are shown below. Table 5.3-1 Examples of command parameters for each function Epson ESC/Label Application Development Guide CW-C4000 Series Rev. C Page 45 Function Command example Description Buzzer ^S(CUB,S,N Printer does not sound buzzer. ^S(CUB,S,E Printer sounds buzzer after printing each label. ^S(CUB,S,L Printer sounds buzzer after printing last label. Pause ^PQ1 Printer prints one label and does not pause. ^PQ1,1 Printer prints one label and pauses after printing one label. ^PQ3,1 Printer prints three labels and pauses after printing one label.
^PQ3,3 Printer prints three labels and pauses after printing three labels. ^PP Printer prints one label and pauses after printing one label. ^PQ3^PP Printer prints three labels and pauses after printing three labels. Cut ^S(CMP,M,T ^S(CMP,M,P ^S(CMP,M,R Printer does not make a cut. ^S(CMP,M,C Printer always makes a cut after the last label. Use in combination with ^PQ to make cuts other than after the last label.