EPSON — 5.3.1 Buzzer

5.3.1 Buzzer  Function Buzzer timing setting  Command code ^S(CUB,S,c  Parameters c = N: Printer does not sound buzzer E: Printer sounds buzzer after printing each label L: Printer sounds buzzer after printing last label This command is used to set how the printer's buzzer operates. To change the volume of the buzzer, use the controls on the printer's panel or the ^S(CUB,Z command. Example 1: Printing three labels, and sounding a buzzer after printing the last label ^XA ^S(CUB,S,L Set printer to sound buzzer after printing last label ^FO0,0^FDprint 3 pages^FS ^PQ3 ^XZ Example 2:

Printing three labels, and sounding a buzzer after printing each label ^XA ^S(CUB,S,E Set printer to sound buzzer after printing each label ^FO0,0^FDprint 3 pages^FS ^PQ3 ^XZ Example 3: Printing three labels without sounding a buzzer ^XA ^S(CUB,S,N Set printer to not sound buzzer ^FO0,0^FDprint 3 pages^FS ^PQ3 ^XZ Example 4: Printing two labels, and sounding a buzzer after printing the last label When specifying whether to sound a buzzer for each ^XA-^XZ, transmit the following commands. ^XA ^S(CUB,S,N ^FO0,0^FDprint 1 page(1 of 2)^FS ^XZ ^XA ^S(CUB,S,L ^FO0,0^FDprint 1 page(2 of 2)^FS ^XZ Epson ESC/Label Application Development Guide CW-C4000 Series Rev. C Page 46