The method for transmitting commands is shown below. If a spot color list file is not applied, the printer control software sends only the spot color list file selection command (^S(CPC, I). In this case, the file name in the command parameter is left blank. If a spot color list file is applied, the printer control software sends the spot color list file selected by the user using the file registration command (~DY). Next, the printer control software sends a spot color list file selection command (^S(CPC, I). The spot color list file name is specified as the command parameter file name.
The printer control software deletes the spot color list file using the file deletion command (^ID) after printing. Note that the maximum file name length that can be set in the command parameter is 8 characters, so the printer control software limits the file name length to 8 characters or less and specifies it in the command parameter. Examples of these commands are shown below. Example 1: Not applying a spot color list file [Setting commands for each printing job] ^XA^S(CPC,I^XZ Set spot color list file to Not apply Example 2: Applying the spot color list file “UCLFILE1.UCL” [Spot color list file registration command] ~DYR:UCLFILE1.UCL,B,UCL,820,0,...
Register spot color list file [Setting commands for each printing job] ^XA^S(CPC,I, R:UCLFILE1.UCL^XZ Set to apply spot color list file Other commands required for printing are omitted. See Chapter 3 for details. [Printing complete commands] ^XA^IDR:*.*^FS^XZ Delete image files and spot color list files registered for printing Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 37