4.5.8 Barcode width correction value setting Function description: Use this function to set the bar width correction value for barcodes. Using the default setting as the standard, you can set 2 grades toward narrowing the bar width and set it 2 grades toward widening (for a total of 5 grades). Default setting: 0 If you change this setting, the bar width will change when barcodes are printed. By correcting the bar width of barcodes, you can prevent reduced barcode scanning quality due to ink bleeding.
Target barcodes UPC-A, UPC-E, JAN13(EAN), JAN8(EAN), Code39, ITF, Codabar, Code93, Code128, GS1- 128, GS1 DataBar Truncated, GS1 DataBar Expanded, GS1 DataBar Limited, PDF417, Micro PDF, GS1 DataBar Stacked, GS1 DataBar Stacked Omnidirectional, GS1 DataBar Expanded Stacked, QR Code, Micro QR, Aztec, DataMatrix If the bar width adjustment is changed by 1 step, the bar width changes by 1 dot at a conversion of 600 dpi. For 300 dpi, a 2-step change makes a change of 1 dot. Even with the default conditions, corrections are made to improve the barcode scanning quality.
When the adjustment value is set to the default setting (0), the bar width is narrowed by 2 dots, at a conversion of 600 dpi in comparison with the width calculated using the standards for each symbol. For 300 dpi, it is narrowed by 1 dot. Usage case: Check the scanning of printed barcodes, and use this function if the scanning quality is low. Implementation recommendations: Inform the user of the risk that the barcode scanning quality might drop paradoxically if the barcode width correction value is changed. Command(s) used: ^S(CBW,C 4.5.9 Print speed setting Function description: Use this function to set the print speed. Select one of the following print speed settings.
300 [mm/s]/150 [mm/s] Default setting: 300 [mm/s] Usage case: Set the print speed slower if processing of an external device connected to the printer is hindered. Printing stops midway during a batch and backfeed is performed to continue printing if data transfer is not completed in time due to print content. In this case, set the print speed slower. Command(s) used: ^S(CMP,S Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 40