4.5.10 Head maintenance setting Function description: Use this function to set execution priority for either print throughput or print quality. Select one of the following head maintenance settings. Table 4.5.10-1 Head maintenance settings Default setting: Pause for maintenance (fine) Setting to “Continuous printing” decreases the print quality and increases the throughput when printing multiple labels. Setting to “Continuous printing” results in a noticeably excess amount of ink being discharged on the print surface. Flush onto paper mode: The higher the level of flush onto paper mode, the greater the amount of ink discharged, thereby reducing the print quality.
However, you can expect the throughput to improve if printing multiple labels because discharging a large amount of ink allows you to increase the time until the periodic flushing that retracts the head and discharges ink is performed. Usage case: Set if you want to change the priority of throughput and image quality Command(s) used: ^S(CMP,F Table 4.5.10-2 Selection of print throughput and speed Pattern A [Recommended]: Select to assign priority to print throughput. Pattern B [Recommended]: Select to assign priority to print quality. Pattern C: Select if there is an issue in connecting with an external device.
(The operation speed of an external device does not satisfy the print speed and Pause for maintenance is not permitted.) Pattern D: Select if there is an issue connecting with an external device. (The operation speed of an external device does not satisfy the print speed and degradation of print quality is not permitted.) Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 41 Head maintenance setting Mode Continuous printing (fast) Flush onto paper mode: Level 2 Pause for maintenance (fine) Flush onto paper mode:
Level 1 Higher ← ◎ ○ △ × → Lower Printing Speed 300 [mm/s] 150 [mm/s] Head maintenance Continuous printing (fast) ◎ △ A △ B ◎ ○ C × × D 〇 Pause for maintenance (fine) Throughput Print Quality Throughput Print Quality