EPSON — 6.1 Transmitting printer settings

6.1 Transmitting printer settings The settings described in this section can be transmitted in a batch, or transmitted individually. To retain the settings in the printer even when its power is turned off, transmit the setting storage command (^JUS) at the end of the setting commands. If the printer control software does not support a particular setting item, the printer control software must not send a command related to that setting item. This is due to the fact that if the printer control software sends that command, the content that has been configured on the printer's panel or with the EPSON tool will no longer be applied to the printer operations.

In addition, to display the current setting values for the printer in the settings window, you can use the ~H(C command supported by the ^S(C command to acquire the setting values from the printer. Examples of these commands are shown below. [Acquire printer settings] ~H(CLM,D Acquire media detection method [Response] ^S(CLM,D,W. Media detection method is gap Repeat transmission of the acquisition command and the reception of a response in the same way.

[Printer settings] ^XA ^S(CLM,F,DL Set media form to die-cut label ^S(CLM,D,W Set media detection method to gap ^S(CLM,P,IR Set media source to internal supply ^S(CLM,S,RP Set media shape to roll paper ^S(CMV,C,6 Set nozzle clog tolerance to 6 [nozzles] ^S(CMV,A,E Set cleaning after self-test to be executed ^S(CMV,S,D Set nozzle self-test to disabled ^S(CMV,I,500 Set self-test interval to 500 [sheets] ^S(CMV,O,C Set operation at clogged nozzle detection setting to Continue printing ^S(CMN,S,E Set nozzle clogging recovery setting to enabled ^S(CLE,T,0 Set print start position adjustment (vertical) to 0 ^S(CLE,M,0 Set print start position adjustment (horizontal) to 0 ^S(CLP,T,0 Set paper top position adjustment to 0 ^S(CLP,O,0 Set cut position adjustment to 0 ^S(CWR,P,Y Set reprint to enabled ^S(CWR,C,Y Set unfinished label cutting to enabled ^JUS Save settings ^XZ Epson ESC/Label Application Development Guide CW-C8000 Series Rev.

B Page 67