EPSON — 6.2 Media form and media detection method setting

6.2 Media form and media detection method setting  Function description:  Use this function to set the media form and label edge detection method (black mark, gap, no mark, hole).  The media form and detection method that match the media set in the printer must be set.  If it is not set properly, the printer cannot detect the label edge correctly.  If the printer cannot detect the label edge correctly, an error will occur after a certain amount of media is fed.  Select one of the following media forms. Die-cut label/Full-page label/Continuous paper/Tag Default setting: Die-cut label  Select one of the following detection methods. Gap/Black mark/No mark/Hole Default setting:

Gap  A list of detection method settings for each media is shown below. Table 6.2-1 List of detection method settings for each media  Usage case:  Set when changing to media with a different form.  Implementation recommendations:  Selectable detectors are determined by the media form. The printer control software informs the user of the available selections based on media form.  Command(s) used:  ^S(CLM,F ^S(CLM,D Epson ESC/Label Application Development Guide CW-C8000 Series Rev.

B Page 68 Media Media form Detector setting Gap-basis die cut label Die-cut label Gap Black mark-basis die cut label Die-cut label Black mark Black mark-basis full-page label Full-page label Black mark Full-page label with no mark Full-page label No mark Black mark-basis continuous paper Continuous paper Black mark Continuous paper with no mark Continuous paper No mark Tag Tag Hole