6.5 Nozzle self-test system setting Function description: This function sets the timing for nozzle self-tests while printing, and the operation at clogged nozzle detection. What is a nozzle self-test? This is a system for automatically detecting clogged nozzles when the printer is turned on and/or each time the number of sheets set by the user is printed. If a clogged nozzle is detected, the user is notified according to the settings. The user can be notified to check the print result and decide to continue printing or cancel printing and the like.
If a clogged nozzle is detected, and if the number of clogged nozzles exceeds the tolerance value, cleaning is performed automatically according to the settings. This allows clogged nozzles to be resolved without the user doing any cleaning. Usage case: Set if you want to minimize poor label printing due to clogged nozzles. Command(s) used: ^S(CMV,S ^S(CMV,I ^S(CMV,O ^S(CMV,C ^S(CMV,A ^S(CMN,S The setting items and their commands are shown below. Table 6.5-1 List of setting values for the nozzle self-test system Epson ESC/Label Application Development Guide CW-C8000 Series Rev.
B Page 70 Classification Item Setting range Recommended initial value Command General settings Nozzle clog tolerance value 0 to 10 6 ^S(CMV,C Cleaning after self-test Execute/ Do not execute during printing/ Do not execute Execute ^S(CMV,A Settings for detection during printing Enable/disable function Enable/Disable Disable ^S(CMV,S Self-test interval 1 to 25000 [sheets] 500 ^S(CMV,I Operation at clogged nozzle detection Continue/Notify Continue ^S(CMV,O Nozzle clog recovery Enable/Disable Enable ^S(CMN,S