EPSON — 6.8 Cut / Specified stop position adjustment

6.6 Print start position adjustment  Function description:  Use this function to make minor adjustments from the base vertical and horizontal positions of the print position.  The base position for the vertical position is determined according to the media detection method.  The base position for the horizontal position is the left gap from the left edge of the media.  Usage case:  Use this function if the print position is not aligned with the label.  Command(s) used  ^S(CLE,T or ^LT ^S(CLE,M An image of how these adjustments are made is shown below. Figure 6.6-1 Print start position adjustment The setting items and their commands are shown below.

Table 6.6-1 List of print start position adjustment setting values Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 71 Item Setting range Default setting Command Vertical direction [mm] -2.0 to +2.0 0.0 ^S(CLE,T Horizontal direction [mm] -1.0 to +1.0 0.0 ^S(CLE,M