6.7 Paper top position adjustment Function description: When the media form is tag, or when using a media form other than tag and the media detection method is “No mark”, this function is used to adjust the print position of the first label from the paper top. The setting range is 0 [mm] to 21.7 [mm]. Default setting: 0.0 [mm] When the media form is tag, or when using a media form other than tag and the media detection method is “No mark”, by default, the paper top is used as the printing base position of the first label from the paper top. The position can be changed using this adjustment.
When the media form is any one of die-cut label, full-page label, or continuous paper and the media detection method is “Gap” or “Black mark”, this adjustment value does not apply, because the printing base position is determined by the detector. This adjustment value does not apply to the printing of second and subsequent labels from the paper top. In connection with the print position, the adjustments of the print start position described in the preceding paragraph are also included. Figure 6.7-1 Paper top position adjustment Usage case: This is used when you wish to provide a particular blank area before the start of the first label printing from the paper top.
Command(s) used: ^S(CLP,T Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 72