6.8 Cut / Specified stop position adjustment Function description: This function adjusts the cut position or the specified stop position. The cut position adjustment is applied when the post-printing operation is set to stop at the cut position (Cut or Do not cut). The specified stop position adjustment is applied when the post-printing operation is set to stop at the specified stop position. Figure 6.8-1 Cut / Specified stop position adjustment Usage case: Use this to adjust the cut position or the specified stop position. If an external device connected to the printer performs cutting or peeling, adjust to a position that is appropriate for processing of the external device.
Command(s) used: ^S(CLP,O or ~TA ^S(CMQ,B The adjustment items and their commands are shown below. Table 6.8-1 List of cut / specified stop position adjustment setting values Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 73 Item Setting range [mm] Default setting [mm] Command Cut position -20.0 to +1.5 0 ^S(CLP,O or ~TA Specified stop position 0.0 to 50.0 0 ^S(CMQ,B