EPSON — 7 Downloading TrueType Fonts

7 Downloading TrueType Fonts  Function description:  Use this function to download TrueType fonts (TTF files) to the printer.  You can download TrueType fonts to the printer, and use the print function for TrueType fonts to print in a way true to the fonts installed in a device.  Reason(s) for this function:  This is to enable printing of various character shapes.  Usage case:  Use this function to print documents using a TrueType font.  Implementation recommendations:  Inform the user that, when downloading a TrueType font to the printer, it is necessary to first get permission from the copyright holder of that font.  Command(s) used:

 ~DY (Use of the ~DU command is not prohibited, but ~DY is recommended.)  Notes  Pay careful attention to the combination of the download command and the extension on the file name at the download destination. The reason is explained below. The extension for font files that are downloaded and saved in the printer are determined by the download command that is used. For ~DY the extension is TTF (when x = T is specified) or TTE (when x = E is specified). For ~DU, the extension is FNT. Even if you specify an extension in the parameter for the download command, it will still be set as described above.

To access the font files that are stored in the printer, you must specify the extension for the file that is actually stored in the printer as the file extension for the command. Commands for accessing font files: ^A@, ^CW, ^ID, ^H(Y, ^HW, ^WD  When using downloaded fonts, be sure to set the character code set as necessary. In addition, depending on the character code set that is used, it might be necessary to set a character code conversion table. Character code sets and their character code conversion tables are shown in Table 7-1. Table 7-1 List of character code sets and their character code conversion tables Request: Do not install UTF-16.

Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 75 Character code set ^CI command Character code conversion table Parameter d:o.x for ^SE KS X 1001(KS C 5601-1987) ^CI14 Z:EUCKR2K6.CNV Shift-JIS ^CI15 Z:SJIS2K3.CNV EUC-JP ^CI16 Z:EUCJPK7.CNV EUC-CN ^CI16 Z:EUCCN199.CNV BIG5 ^CI26 Z:BIG52K7.CNV GB18030 ^CI26 Z:GB18030.CNV UTF-8 ^CI28 N/A (Not recommended) UTF-8 ^CI17^F8 N/A (Not recommended, limitations) UTF-16 ^CI17 N/A (Cannot be used) UTF-16 ^CI29, ^CI30 -