CHASSIS MODIFICATIONS 2-84 E URO C ARGO E URO 4 - 5 The chassis is the return. The contact surfaces of the connection to the current drawing point should be sufficiently large for quantity of current to be drawn (the maximum drawable current limit is as specified in point a: current draw-off from batteries). For this purpose use nuts and washers to secure the draw-off points to the battery disconnector threaded terminal. Install a fuse downstream of the disconnector and use wires of suitable cross-section for the current level, as specified in the Table 2.18. The outcoming wires must be routed parallel to the reference surface, i.e. as close as possible to the chassis/body structure.
Always shield the wires with corrugated piping and isolate the contact with a wire-isolating cap of the correct size. Isolate the battery disconnector threaded terminal (positive pole) if no current is being drawn from the battery. ! c) 21 pin connector (brown) : ST13 From the 21-pin connector placed in the ECU housing (under the panel on the bottom, passenger side) it is possible to draw current from pins 11 and 21. This current draw is protected by two fuses: For further details see para 5.2. d) Side Marker Light connector In some countries, regulations (domestic or EC) require the vehicle to be equipped with side marker lights, depending on its overall length.
EuroCargo Restyling 2004 range vehicles are fitted with a specific female, super-sealed female connector for connecting the sidelights to the power supply. The connections and the lighting system shall be installed by bodybuilder on the corresponding supplementary structures (bodies, vans, etc.). The positions of these terminals are shown below. ! Leave the cap supplied by IVECO in place in order to protect the female connector electrical contacts over time. Operations on the electrical system Base - July 2006 Revi - June 2007 Print 603.93.431 POSITION MAXIMUM LOAD DESCRIPTION F9 10A K30 F15 5A K15