Iveco — EuroCargo E4 BODYBUILDER INSTRUCTIONS

SPECIFIC INFORMATION AND INSTRUCTIONS 5-17 E URO C ARGO E URO 4 - 5 Predisposition for loading gate + 2 nd ECAS remote control - opt 4115 5.5 Tail lift preporation pack + 2 nd ECAS remote control - opt 4115 For vehicles with pneumatic suspension (/P and /FP), it is possible to order optional 4115, 2 nd ECAS remote control (in addition to the standard remote control). The optional consists of specific wiring and of the 2 nd remote control, which can be connected near the tail lift. Optional 4115 is available exclusively in conjunction with optional 4113 (predisposition for tail lift, see previous paragraph).

When you operate the switch for activating the tail lift, the standard ECAS remote control is disabled and the second remote control is enabled. Operating the switch again restores the original state. Figure 5.6 - Basic wiring diagram for vehicles with opt 4115 TO ECAS ECU TO CONTROL BOX D THRU CONNECTOR 116428 5.6 FMS The fleet management systems are integrated in the VCM. The data, transmitted according to the FMS standard (visit www.fms-standard.com), can be acquired in real time by an on-board computer. As a result of processing the data, it is possible:

− to obtain information aboutthe operating conditions of the vehicle (times, distances, fuel consumption, etc.); − analyse the operating conditions of the engine and the use of the braking system; − analyse the distribution of the distances travelled, speed, frequency of stops and starts. The installation of the on-board computer, hardware and software for data processing and management is the task of the ICT installer. Predisposition for loading gate + 2nd ECAS remote control - opt 4115 Print 603.93.431 Base - July 2006 Revi - June 2007