System Messages - Alphabetical List User action: Manually move the robot back into range and re-enable power. Check the the negative overtravel switch and its wiring. Use the CONFIG_C utility to adjust the robot soft limits so they are inside the hard limits. *Negative square root* (-410) Explanation: An attempt has been made to calculate the square root of a negative number. User action: Correct the program as required. *Network closed locally* (-535) Explanation: An attempt has been made to access a DDCMP serial line when the protocol is not active. The protocol was probably stopped because of some other error condition. User action: Restart the DDCMP protocol.
*Network connection closed* (101) Explanation: A client connection has closed on the given logical unit. User action: None. This is an informational message. *Network connection opened* (100) Explanation: A new client connection has been established on the given logical unit. User action: None. This is an informational message. *Network connection terminated* (-565) Explanation: This error occurs when input or output operations are attempted on a network connection that has already been terminated. User action: Reestablish the network connection, and retry the original operation. *Network error* Code n (value received) Explanation:
An error code between -255 and -1 (inclusive) has been received from the network. The error code, which does not have meaning to eV+, is being reported to you. User action: Application dependent. If the indicated code does not having meaning for the current application, verify that the remote computer is sending valid data. *Network node off line* (-538) Explanation: An attempt has been made to send data to a known network node that is off- line. Either the node has been disabled, or it is not connected to the network. eV+Language Reference Guide, v2.x, 18319-000 Rev A Page 628