Downloaded from https://www.everyspec.com MIL-HDBK-816 NOTICE 1 2.2.2 Other Government documents, drawings, and publications. The following other Government documents, drawings, and publications form a part of this document to the extent specified herein. NATIONAL AERONAUTICS AND SPACE ADMINISTRATION (NASA) SCR-607 - Factors for One-Sided Tolerance Limits and for Variables Sampling Plans. (Copies are available from the National Aeronautics and Space Administration (NASA), Ames Research center, Mail Stop 213-4, Moffett Field, CA 94035.) NATIONAL TECHNICAL INFORMATION SERVICE (NTIS) Experimental Statistics Handbook (Copies are available from the U.S.
Department of Commerce, National Technical Information Service, 5285 Port Royal Road, Springfield, VA 22161.) 2.3 Non-Government publications. The following documents form part of this document to the extent specified herein. Unless otherwise specified, the issues of the documents which are DoD adopted are those listed in the latest issue of the DoDISS, and supplement thereto. AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM) Annual Book of ASTM Standards International, Volume 12.02 - Nuclear, Solar, and Geothermal. Annual Book of ASTM Standards International, Volume 10.04 and 10.05 - Electronics.
(Application for copies should be addressed to the American Society for Testing and Materials International (ASTM), 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.) EIA/JEDEC STANDARDS EIA/JEDEC-57 - Test Procedures for the Measurement of Single Event Effects in Semiconductor Devices from Heavy Ion Irradiation. JESD-89 - Measurement and Reporting of Alpha Particles and Terrestrial Cosmic Ray-Induced Soft Errors in Semiconductor Devices. (Application for copies should be addressed to Global Engineering Documents, 5 Inverness Way East, Englewood, CO 80112-5704.) 2.4 Order of precedence.
In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. 3. ACRONYMS, DEFINITIONS, AND SYMBOLS 3.1 Acronyms used in this handbook. The acronyms used in this handbook are defined as follows:
ASTM - American Society for Testing and Materials DSCC - Defense Supply Center, Columbus DNA - Defense Nuclear Agency (now DTRA) DOD - Department of Defense DTRA - Defense Threat Reduction Agency DTRIAC - Defense Threat Reduction Information Analysis Center EPL - End Point Limits ERRIC - Electronics Radiation Response Information Center ESD - Electrostatic Discharge GQ - General Qualification SUPERSEDES PAGE 4 OF MIL-HDBK-816 4