N/A (no manufacturer mentioned) N/A — MIL-HDBK-304C Package Cushioning Design Handbook PDF Download

Downloaded from https://www.everyspec.com MIL-HDBK-304C 5.3.3.4 Acceleration. Acceleration is the rate at which velocity changes. It is measured in meters/sec/sec, inches/sec/sec, or similar units. It is generally defined as a percentage of Earth’s gravitational acceleration at sea level (g) = 9.8 m/sec/sec (386 in/sec/sec) which is a constant. Therefore, 10G equals 10 times 9.8 m/sec/sec. (See equation 5:1 ) 5.3.3.5 Peak Acceleration and Deceleration. Peak acceleration is also the peak or the high point of the acceleration vs. time pulse. Note that deceleration is negative acceleration.

The two terms are often used interchangeably, although acceleration properly refers to an increasing rate of velocity change whereas deceleration describes a decreasing rate of velocity change. (Acceleration is the differential of velocity with respect to time). In package testing, acceleration is measured with an accelerometer on the item. The accelerometer’s output is in G’s. Section 8.0 discusses package testing in detail. See Figure 5-4 for an example of acceleration versus time output. G = a/g (5:1) Where:

G = output ratio of the item’s acceleration over earth’s gravitional acceleration a = input acceleration (units of m/sec/sec or in/sec/sec) g = earth’s graviational acceleration [Constant of 9.8 m/sec/sec (386 in/sec/sec)] Velocity Change ( V) is another unit often used in dynamic packaging work. It refers to the difference between initial and final velocity and can be thought of as a measure of energy dissipated. It is equal to the area under the acceleration vs. time pulse (the integral of the pulse) See Figure 5-4. V = Peak Acceleration x Effective Duration (5:2) 23