MIL-HDBK-304C Cic is the cost of the interior container in dollars. Cec is the cost of the exterior container in dollars. CL is the cost of the labor per man-minute in dollars. Pp is the labor in man-minutes that is required to fabricate and apply the platens or die-cut trays. Pic is the labor in man-minutes that is required to set up, load, and close the interior container. Pec is the labor in man-minutes that is required to set up, load, and close the exterior container. Cs is the cost of shipping the complete package to its destination. Note 1:
The cost of storage of cushioning materials prior to use is excluded from this formula because it is highly intangible and usually considered to be part of overhead. 5.8 Recoverability (Compression Set) Cushioning materials have varied ability to regain original thickness in the direction of compressive deformation after removal of the load. In the field of packaging it is common to express any deviation from perfect recoverability (100 percent of original thickness) as "set", because most cushioning applications involve compression loading of cushioning materials, the set is usually "compression set". Various types of loading can cause compression set.
During shelf storage wherein materials are subjected to relatively long-term static compressive loads, most cushioning materials tend to acquire a certain amount of compression set. Similarly, dynamic compression loading occurring during shipment can cause compression set. Because compression set can be caused by various forms of loading, several procedures are recommended herein for evaluation of this characteristic (See paragraph 9.1). Compression set is undesirable in cushioning material for two principal reasons:
(1) Looseness (and the related increased likelihood of damage) (2) With some cushioning materials it indicates that the compressive stress-strain behavior of the material has changed and the possibility of damage caused by "bottoming" has also increased. Some effects of looseness in a packaged item. See Figure 5-13.
Where ( A ) represents a cushioned item being displaced normally from its original position during a drop against a flat rigid surface; ( B ) illustrates the same item in a different position due to jostling and looseness and thus receiving an impact on a point; and ( C ) represents a loosely packaged item moving in a direction opposite from that of the exterior container and cushioning. The instance of ( C ) could occur during vibration of the package as it rests on the bed of a truck or rail car; the vibration causes larger peak forces and accelerations to be developed and these, in turn, increase the likelihood of damage to the item.
Compensation for compression set is usually accomplished by: (1) Designing according to data that have involved a realistic amount of preworking prior to test (paragraph 9.1.16) and repetition of impacts, or (2) Applying an excess of cushioning material in pre-compressed condition [usually accomplished indirectly when such compensation is made for creep (paragraph 5.8.3)]. 34 Downloaded from https://www.everyspec.com