MIL-HDBK-304C 7.0 CUSHIONING DESIGN PROCEDURES 7.1 Cushioning Design Procedure Summary. Rational cushioning design requires consideration of many factors as listed in Section 5.0. Therefore, the following Container Development Procedures given in Table III provide a summary of the steps required in the cushion design procedure. A typical comprehensive cushioning problem follows in paragraph 7.2. 7.2 Comprehensive Sample Problem. Twenty video display units are to be repackaged individually for shipment to various locations worldwide in moderate but known conditions. Each package must contain sufficient cushioning to allow the item to withstand flat and cornerwise drops.
The item size is 20x20x16--inches (0.51x0.51x.41--meters) and the item weight is 40 lb (18 kg). The item can withstand up to 40 G’s. The item is used for deployment, and the expected number of trips for the item is 40. Each trip is estimated at 1200 miles mostly by truck, some by air. The estimated gross weight of the container and its contents is 60 lb using a plastic container (See reasoning in Step 5). Determine the most economical cushioning design and interior container size. SOLUTION: (by procedure of Table III) Step (1) Define the Shipping, Handling, and Storage Environment Level B -- Moderate worldwide shipment, known conditions, moderate value Gross Weight (Shipping Weight):
60 pounds (27 kilograms) Look at Table IV Drop Height -- 24" (0.6 meters) Estimated Shipping: 1200 miles, Truck Step (2) Determine Item Characteristics Dimensions -- 20" x 20" x 16" (0.51x0.51x.41--meters) Fragility -- 25 G's Item Weight -- 40 pounds (3.4 kg) Moderate Value Quantity -- 20 Step (3) Product Redesign Comparing the moderate value of the item with low cost of Level B packaging and since the production rate is not high, little prospect exists for appreciable savings by refining the item’s design.
Step (4) Design Cushioning System The package designer can work the problem solving for each material and then determining which is the best material based on cost, material characteristics and the container size based on the Peak G/Static Stress Curves in Appendix B. The package designer could also work the problem using “Package Designer” software (See 7.3). The designer would then choose the best material based on cost, material characteristics and the container size from the solutions given in the results. (Suggestion: If you do use the computer program, it is best to work out in long hand your top picks to determine the best material.
Remember to look at other cushioning characteristics from Section 5.0 when choosing a material.) See Figures 7-1 and 7-2 for the computer solutions of this problem. There are 13 complete encapsulation solutions and 10 cornerpad solutions for this problem. To save on space, only the 52 Downloaded from https://www.everyspec.com