MIL-HDBK-304C top three picks of each configuration are shown here. (Note that fiberboard is listed as the exterior container in the program. Even though the computer program does not have plastic as an option, it is still the choice for the exterior container because of the environmental conditions the video display unit will encounter. The type of exterior container does not effect the outcome of the cushioning design.) Note: After the package designer has completed their design, it is essential testing be performed to ensure that the container system will withstand the expected container life and the predicted environments. TABLE IX Analysis of Best Materials. -- Decision:
The cornerpad solutions are the most economical. Although, the container size is slightly smaller with complete encapsulation. Because the container is plastic, the cost differential will be higher than with fiberboard, so a smaller container is more desirable. Because the container size is not much larger, the designer talks to the user. They would like the least cube as possible because they will be deploying with this piece of equipment and they need all the room they can get. The choice is complete encapsulation in Polyurethane Ether, 1.5 pcf. Step (5) Design the Package System The interior dimensions of the container using Polyurethane-Ether 1.5 pcf are 24” x 24” x 20”.
Because the video display units are being deployed in these containers and the field predicts many trips, this package designer chooses plastic containers for their added durability and moisture resistance over fiberboard. Step (6) Test the Package/Cushioning System Instrumented drop tests of a complete package containing a dummy item and cushioning, from a height of 24 inches (0.60 meters), yield the following results: Flat drop (on bottom)--29 G; flat drop (on end)--35 G; and corner-wise drop--33 G. Based upon the test results, it is decided to accept the design.
The accepted cushioning design is not excessively conservative because some safety margin is desirable to hedge against variation in material performance and the severity of service handling conditions. 7.3 Cushion Design by Computer. 53 Downloaded from https://www.everyspec.com Cushion Material Cushion Dimensions (Inches) Interior Cntr. Dimensions (Inches) Config.
Cost Polystyrene, 1.5 pcf 2.8”x2.8”x3, 2.8”x2.8”x3, 2.8”x2.8”x3 26”x26”x21” Corner- pad $19.50 Polyurethane, 1.5 pcf 3.7”x3.7”x3”, 3.7”x3.7”x3”, 3.7”x3.7”x3” 26”x26”x21” Corner- pad $22.21 Polystyrene, 2.5 pcf 2.3”x2.3”x4”, 2.3”x2.3”x4”, 2.3”x2.3”x4”, 28”x28”x23” Corner- pad $22.49 Polyurethane Ether, 1.5 pcf 20”x20”x2”, 20”x20”x2”, 20”x24”x2” 24”x24”x20” Complete Encap. $24.47 Polyurethane Ether, 2 pcf 20”x20”x2”, 20”x20”x2”, 20”x24”x2” 24”x24”x20” Complete Encap. $26.36 Rubberized Hair, Type III 20”x20”x2.5”, 20”x20”x3”, 21”x26”x3” 26”x26”x21” Complete Encap. $29.43