MIL-HDBK-304C The third element in signal recording is the data capture system. This system can be as simple as a storage oscilloscope or as complex as a computer controlled data acquisition system where the data is digitized and stored for later analysis by sophisticated computer software. For information on recording instrumentation, refer to paragraph 8.3.3. 9.1.5.5 Test Specimens. Generally five test specimens are required. An extra specimen is required as a velocity test cushion for determining free fall drop height. Check the specific foam material specification for the number and size of cushions needed. Dimensions should be measured per paragraph 9.1.2.
The weight and density of the test specimens should be determined per paragraph 9.1.3. 9.1.5.6 Conditioning. Test specimens will be conditioned per paragraph 9.1.1.4. 9.1.5.7 Prework. When required, prework material per paragraph 9.1.16. 9.1.5.8 Test Procedure. Note: The following is an example of a cushion curve test procedure. Use the specific foam material specification for the exact procedure. Adjust the dropping head weight for the lowest static stress point. Using the velocity test cushion as a target, adjust the dropping head release point to obtain the desired equivalent free fall drop height velocity.
When this height has been set, replace the velocity test cushion with the first test specimen and begin the test sequence. Impact each test specimen five times. Record the dropping head acceleration versus time record and peak acceleration during cushion compression for each drop. Allow a minimum of one minute between drops on the same cushion. To speed up the testing procedure it is useful to perform the first drop on all of the test specimens before performing a second drop on the first specimen. After completing all five drops on all test specimens increase the dropping head weight for the next static stress point. Again use the velocity test cushion to adjust the free fall drop height.
Then repeat the five drop sequence on the test specimens. Testing will be done at each of the chosen static stress points progressing from the lowest to the highest static stress point. If the testing is to be used for material qualification purposes, do not replace the test specimen at each static stress point. If the testing is to be used for design purposes, replace the test specimen at each static stress point. If dynamic set is to be calculated, measure the test specimen final thickness one hour after impact testing per paragraph 9.1.2. Note:
For further information on Dynamic Compression Test Procedures see ASTM D 1596, Standard Test Method for Dynamic Shock Cushioning Characteristics of Packaging Material and the foam material specifications listed in Section 2.0. Also see ( 17 ) in Appendix D. 9.1.5.9 Calculations. 9.1.5.9.1 Average Peak Acceleration Values. At each static stress, disregard the first peak acceleration value on each specimen and average the remaining four peak accelerations. Then average these average peak acceleration values to obtain an overall average peak acceleration value for each static stress point. 9.1.5.9.2 Dynamic Set. Dynamic set should be calculated as follows:
To - Tf Set = _______ x 100 % (9:2) To where To = original specimen thickness; Tf = final specimen thickness. 76 Downloaded from https://www.everyspec.com