MIL-HDBK-304C APPENDIX B PEAK ACCELERATION - STATIC STRESS CURVES Peak acceleration-static stress curves for the materials listed in Table VIII are for drop heights of 12, 18, 24, 30, 36, 42 and 48 inches. Material thicknesses are given in inches at the end of each curve. The peak acceleration-static stress curves are available apart from this document in electronic format through AFPTEF. The peak acceleration-static stress curves are unchanged from the previous version and are not reprinted in this version. You can access these charts on the internet or you can write or phone AFPTEF to get an electronic copy on disk.
AFPTEF's internet address, mailing address and phone and fax numbers are listed below. Another way to get design curve information is through the Package Designer Program (See 7.3). For discussion of the derivation peak acceleration-static stress curves, refer to 9.1.5; for details about their use, refer to 5.4.1. All data given herein were derived from empirical tests conducted by contract for AFPTEF, Wright- Patterson AFB OH, under controlled atmospheric conditions of 73єF and 50 percent relative humidity and are generally representative of commercially available materials (See Table VIII).
However due to manufacturing variations in some materials, shock levels in the resulting package may not be identical to the data represented here. If excessive variation is suspected, free fall drop testing as outlined in paragraph 8.2.2 is encouraged to verify desired levels of protection. AFPTEF AFMC LSO/LOP 5215 Thurlow Street Wright Patterson AFB OH 45433-5540 Commercial Phone: 937-257-4519 DSN Phone: 787-4519 Commercial Fax: 937-656-1350 DSN Fax: 986-1350 Internet Address: http://packweb.wpafb.af.mil 87 Downloaded from https://www.everyspec.com