MIL-HDBK-304C APPENDIX C TRANSMISSIBILITY - FREQUENCY CURVES Transmissibility-frequency curves are for 1, 2, 3, 4, 5, and 6 inches of material thickness at ten different static stress levels are available apart from this document in electronic format through AFPTEF. The transmissibility-frequency curves are unchanged from the previous version and are not reprinted in this version. You can access these charts on the internet or you can write or phone AFPTEF to get an electronic copy on disk. AFPTEF's internet address, mailing address and phone and fax numbers are listed below.
Paragraph 5.5 describes the Derivation and the use of transmissibility curves, while testing for transmissibility is discussed in paragraph 9.1.6. All data were derived from empirical tests conducted by contract for AFPTEF, under controlled atmospheric conditions of 73єF and 50 percent relative humidity and are generally representative of commercially available materials (see Table VIII). However, due to manufacturing variations in some materials, transmissibility levels in the resulting package may not be identical to the data represented here. If excessive variation is suspected, transmissibility testing as outlined in paragraph 9.1.6 is encouraged to verify desired levels of protection.
AFPTEF AFMC LSO/LOP 5215 Thurlow Street Wright Patterson AFB OH 45433-5540 Commercial Phone: 937-257-4519 DSN Phone: 787-4519 Commercial Fax: 937-656-1350 DSN Fax: 986-1350 Internet Address: http://packweb.wpafb.af.mil 88 Downloaded from https://www.everyspec.com