Downloaded from https://www.everyspec.com MIL-HDBK-695D 3. DEFINITIONS 3.1 Age resistance - Resistance to deterioration in storage by environmental factors, such as heat, light and ozone. 3.2 Cure date - The date the rubber is fully cured. Two methods in expressing the cure date are as follows: a. Shelf life to a maximum of 3 years. Cure date stated in terms of month of calendar year and the year, i.e., 6-83. b. Shelf life in excess of 3 years. Cure date stated in terms of the quarter of calendar year and the year, i.e., 2Q-83. 3.3 Acceptance Life - This is the maximum life at the age at acceptance. The age limit at acceptance for hoses and hose assemblies is 32 quarters.
See SAE AS1933 for aerospace hoses. 3.4 Shelf life - The maximum period of time, from cure date, to the date the elastomeric product is used as a component part in subassemblies, assemblies and systems. During the shelf life time, the stored elastomeric product is expected to retain its characteristics as originally specified. 3.5 Service Life - A general term used to quantify the average or mean life of an item while in use.
Service life, which is depicted in years, is the number of years of economical service reasonably expected of equipment as established in applicable DoD, Service, and/or Agency manuals, bulletins, regulations, instruction manuals, and/or the technical judgement of the item and/or equipment manager. 4. GENERAL GUIDANCE 4.1 Introduction. The most important factors involved in the shelf life of rubber products are (1) the initial quality level of the product, (2) the quality assurance provisions of the specification under which the item was procured, and (3) the age resistance of the rubber from which the product was fabricated.
The relative importance of these factors is difficult to assess, especially because the age resistance of the raw rubber does not always correspond to the age resistance of the finished product. For example, consider two items both fabricated from the same nitrile base polymer, one meeting a specification having comprehensive requirements; the other meeting a specification with loose requirements. In the first instance, it is quite probable that good age resistance will be "built in" to the product by virtue of the optimum compounding ingredients and fabrication techniques that must be employed in order to manufacture the high quality product required by the specification.
In the latter instance, it is likely that the product will have lesser resistance, consistent with the minimal demands of the specification. 4.2 Basis for detailed requirements. The following guidelines were used to establish the expected shelf life periods listed. a. It was assumed that each rubber product met the initial requirements of the applicable specification. b. It was assumed that each rubber product was packaged and stored in the manner prescribed, in order to minimize deterioration due to such factors as temperature, humidity, ozone, sunlight, oils, solvents, corrosive liquids and fumes, insects and rodents. c.
The severity of the specification requirements for an item was considered, especially those requirements that related to age resistance, such as resistance to accelerated air aging, resistance to ozone, compression set and cyclic performance at temperature extremes. 3