U.S. Department of Defense MIL-HDBK-704-3 — NOT MEASUREMENT

Downloaded from https://www.everyspec.com MIL-HDBK-704-3 METHOD TAC108 DC Voltage Component POWER GROUP: Three Phase, 400 Hz, 115 V AIRCRAFT ELECTRICAL OPERATING CONDITION: Normal PARAMETER: DC Voltage Component 1. Scope. 1.1 Purpose. This test procedure is used to verify that three phase, 115 Volt, 400 Hz power utilization equipment operates and maintains specified performance when subjected to a direct current component of AC voltage as specified by the applicable edition(s) of MIL-STD-704. 2. Validation criteria.

The utilization equipment is considered to have passed if the utilization equipment operates and maintains performance as specified in the utilization equipment performance specification document for normal aircraft electrical conditions when subjected to a direct current component of AC voltage as specified by the applicable edition(s) of MIL-STD- 704 and as noted in table TAC108-I. The utilization equipment must maintain specified performance for a length of time that confirms the utilization equipment can operate continuously when subjected to a direct current component of AC voltage and should be not less than thirty (30) minutes.

The utilization equipment must not suffer damage or cause an unsafe condition. TABLE TAC108-I. MIL-STD-704 limits for direct current component of AC voltage. 3. Apparatus. The test equipment should be as follows: a. Programmable AC power supply b. True RMS voltmeter (with capability to measure DC component of AC waveform) c. Frequency counter 4. Test setup. Configure the test setup as shown in figure TAC108-1. Measurements, except current, must be made within 10 cm of the input power terminals of the UUT. 5. Compliance test. With the power source off, install the UUT and the stimulation and monitoring equipment into the test setup of figure TAC108-1.

Set the programmable power supply to produce voltage waveforms having a DC component on each of the three phases for 44 Limit 704A 704B 704C 704D 704E 704F DC Voltage Component of the AC Voltage ! 0.10 V ! 0.10 V ! 0.10 V ! 0.10 V ! 0.10 V ! 0.10 V