everyspec.com — everyspec.com — MIL-HDBK-310: Global Climatic Data for Developing Military Products (PDF Manual)

Downloaded from https://www.everyspec.com MIL-HDBK-310 1. SCOPE - This handbook provides climatic data primarily for use in engineering analyses to develop and test military equipment and materiel. 1.1 Purpose. The data provided are intended to serve as natural environmental starting points for the sequence of engineering analyses to derive environmental design criteria for materiel. The climatic data are also intended to provide guidance in the development of environmental tests of materiel. 1.2 Application. (a) This handbook provides climatic information for land, sea, and air environments in which military materiel may be required to operate.

These data represent free air (ambient) conditions, and are not to be confused with the response of materiel, either to these conditions, or to those of a platform on or within which the materiel might be located. (b) Selection of specific climatic values in this handbook should be made only after determining: (1) the area of geographic deployment; (2) handling and logistics requirements; and (3) the operational requirements of the materiel being developed (see 4.3.3). 1.3 Limitations (a) Climatic data for the region south of 60 ° S latitude are excluded from consideration in this document.

(b) The climatic data in this handbook should not be used in the development of materiel for a specific geographic location or an anomalous site such as a mountain top. This type of climatic support may be obtained through the Office of Primary Responsibility (OPR) for each military service (see 4.6). (c) The possible adverse effects of climatic conditions upon materiel are not discussed in this handbook. (d) This handbook does not include induced environments such as may be encountered in storage or transit, or caused by a platform on or within which the materiel might be located.

(e) Unless otherwise indicated, information provided for a climatic element does not occur at the same time and/or place as information provided for another climatic element. (f) The climatic data in this handbook should not be used directly as test values without consulting MIL- STD-810 or other appropriate environmental test documentation. 2. APPLICABLE DOCUMENTS 2.1 General. The documents listed below are not necessarily all of the documents referenced herein, but are the ones that are needed in order to fully understand the information provided by this handbook. 2.2 Government Documents.

MILITARY STANDARDS MIL-STD-1165 - Glossary of Environmental Engineering Terms and MIL-STD-810 - Environmental Test Methods and Engineering Guidelines (Unless otherwise indicated, copies of the above standards are available from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094). 2.2.1Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a part of this document to the extent specified herein.

Unless otherwise specified, the issues of these documents are those listed in the issue of the Department of Defense Index of Specifications and Standards (DoDISS) and supplements thereto, cited in the solicitation. When this standard is used by acquisition, the applicable issue of the DoDISS must be cited in the solicitation. 2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained. 3. TERMS AND ABBREVIATIONS 3.1 Terms.

Definitions for the scientific and meteorological terms used herein can be found in Mil-Std-1165. 3.2 Abbreviations. The following abbreviations are used in this handbook: (a) Bph - British thermal units per square foot per hour (b) fps - Feet per second 1