Downloaded from https://www.everyspec.com MIL-HDBK-310 (c) LST - local standard time (d) MIX. RAT. - Mixing ratio (e) mps - Meter per second (f) ppm - Parts by weight of water vapor per million parts of dry air (g) RH - Relative humidity (h) SOL. RAD. - Solar radiation 4. GENERAL INFORMATION 4.1 General. Climatic data in this handbook are generally presented in the form of frequencies-of-occurrence. Specific examples are as follows: (a) For both worldwide and regional applications, the frequency of occurrence of climatic elements (e.g., temperature) is based on hourly data wherever possible.
From hourly data, it is possible to determine the total number of hours a specific value of a climatic element: is equaled or exceeded. For example, if a temperature occurs, or is exceeded for an average of 7 hours in a 31-day month (744 hours), it has occurred roughly 1 percent of the hours in that month; if it occurs, or is exceeded, an average of 74 hours in the month, then it has a frequency-of-occurrence of 10 percent, etc. The value that is equaled or exceeded 1 percent of the time is referred to as the 1-percent value. (b) Data on long-term climatic extremes are also provided for most climatic elements.
These are values that are expected to occur at least once, for a short duration ( 3 hours), during approximately 10, 30, and 60 years of exposure. Therefore, they are rarer climatic events than those in 4.1(a). The most extreme value ever recorded is also provided for each element. (c) Worldwide climatic information for each element (or combination of elements) represents conditions in the most severe non-anomalous area in the world for that element (or combination). (d) Regional climatic information for each element (or combination) represents conditions in the most severe non- anomalous part of the region (see 4.2).
(e) Values occurring for specified frequencies-of-occurrence during the worst month may also occur in other months, but with a lower frequency-of-occurrence. 4.2 Regional Information. Regional information is as follows: (a) The land and sea surface areas of the world are divided into five types of climate, subsequently referred to as 'regional types." Four regional types represent land environments and one represents sea surface and coastal areas. Each regional type represents climatic conditions in one or more areas.
Data for these regional types apply in cases where surface-based (land or sea) equipment is not intended for worldwide use, but will be used in one or more (but not all) of the regions. However, potentially dangerous items, or materiel that would become permanently inoperable due to one- time exposure to climatic conditions in any of the land regional types, should be designed for the appropriate worldwide climatic conditions. (b) The land areas of the world are partitioned into four regional types based on temperature characteristics. Regions represented by the regional types for the land areas of the world are shown in Figure 1 (page 101).
Climatic information for these regional types is presented as daily cycles of coincident temperature, humidity, and solar radiation. Additional environmental elements or combinations of elements that could occur and cause problems are specified for each regional type. (c) The coastal/ocean regional type includes all coastal ports and open seas that could involve naval operations. This does not include conditions encountered by ships involved in icebreaking operations or ports when they are closed due to ice. 2