Downloaded from https://www.everyspec.com MIL-HDBK-310 4.3 User Guidance 4.3.1Presentation of the Data. Data is presented as follows: (a) Climatic information for each element (or combination) in section 5 generally includes the recorded extreme, the frequency of occurrence during the most severe month of the year, and long-term climatic extremes. Data on diurnal cycles are presented where appropriate. Interpolation will provide intermediate values of elements between specified frequencies. Extrapolation should not be used to make estimates outside the range of values in section 5.
(b) Upper-air climatic data as a function of altitude are presented in tables of the 1-, 5-, 10-, and 20-percent frequencies-of-occurrence, and recorded extremes, for each element. These are envelopes of extreme conditions at each altitude and do not represent internally consistent profiles, since values for each altitude would not occur simultaneously at any one location or region. Consistent upper-air profiles of temperature, density, and rainfall rate/water concentration versus altitude that occur at the same time and place are also presented. For temperature and density, these are based on specified percentiles at selected altitudes.
Precipitation-rate profiles are based on specified surface extremes. 4.3.2Additional Information. Appendix A provides additional information for the climatic elements, regional climatic types, or upper air environments discussed in section 5. References to scientific reports and journal articles from which the data were taken, and other sources of information are also provided. 4.3.3Data Application. Specific data application is as follows: (a) To use the climatic information in this handbook, the areas of the world that equipment could encounter during its life cycle must be known.
This includes the geographical locations through which an item may be transported, where it may be stored, and where it may be deployed. It is also necessary to know how it will be transported and under what circumstances it will be protected from the environment. (b) It would often be costly or technologically impossible to design materiel to operate under the most extreme environmental conditions ever recorded. Therefore, military planners accept equipment designed to operate under environmental stresses for all but a certain small percentage of the time. The agency or department responsible for the development of materiel shall determine the operational requirements of the item or system.
These requirements should then be used to determine the acceptable frequency of occurrence of a climatic element. Frequencies-of-occurrence that are recommended for initial consideration are discussed in section 5.1 for the Worldwide Surface Environment, 5.2.5 for the Coastal/Ocean Regional Type, and sections 5.3.1 and 5.3.2 for the Worldwide Air Environment. These recommended frequencies were taken from inputs to MIL-STD-210B by the Joint Chiefs of Staff, Memorandum for the Secretary of Defense, JCSM-502-69, 12 August 1969. (c) For some materiel, one-time exposure to a climatic extreme can render it permanently inoperable or dangerous (e.g., ordnance).
For such materiel, long-term climatic extremes, or the record extreme, would be more appropriate for design of equipment that is not protected from the environment. (It should be noted that highest/lowest recorded extremes depend upon the period-of-record and should not be construed as "all time" extremes). The use of these more extreme values, instead of those occurring for a percent of the time during the most severe month each year, shall be determined by the agency or department responsible for development. 3