Downloaded from https://www.everyspec.com MIL-HDBK-310 5.1.14 Ice Accretion. Ice accretion can be a major destructive force to structures, such as towers, located in middle and high latitudes just about anywhere in the world. Concurrent or subsequent strong winds may be the critical force in damaging equipment loaded with ice. There are three basic kinds of ice formed by accretion in the atmosphere: glaze, hard rime, and soft rime. Glaze occurs when rain (sometimes drizzle) freezes on objects; it is clear and nearly as dense as pure ice. Hard rime is less transparent than glaze because of air trapped in the ice. The density with respect to water (specific gravity) varies from 0.6 to 0.9.
It is usually the result of freezing drizzle, but may occur from exposure to supercooled cloud droplets during high winds with the temperature near freezing. Soft rime ice occurs when supercooled clouds or fog droplets freeze upon impact with surfaces colder than 0 ° C. It is opaque with a specific gravity of 0.2 to 0.5. It occurs most commonly on hills or mountaintops exposed to clouds at freezing temperatures. Unfortunately, quantitative records of glaze and rime are not available because icing has not been routinely observed at operational weather stations.
In order to determine reasonable values of ice and wind loading, it was necessary to study case histories of major ice storms, when structures have failed due to the strain of combined ice and wind loading. 5.1.14.1 Highest Recorded. Not available. 5.1.14.2 Frequency of Occurrence. Except for locations such as mountaintops exposed to supercooled clouds, the frequency of occurrence is normally quite low. Equipment exposed to the environment should be designed to survive the extreme accumulation of ice and concurrent wind expected to occur once over a period of years. 5.1.14.3 Long-term Extremes.
These values are estimated to occur once in ten years at icing-prone locations such as eastern Labrador, Canada. More severe conditions will be found on cloud-immersed mountain peaks during periods of continuous passage of supercooled water clouds (specific information will be required for equipment designed especially for such installations). Strong winds are frequently associated with icing, occurring during its formation or after it has formed but before melting. Forces of such winds must be added to forces due to ice accretion as part of the stress in design for ice accretion. Values of ice provided below are thicknesses extending horizontally into the wind.
They apply to structures extending up to heights of 125 m. Associated wind loading can be considered as gusts of 100 knots at about 10 m increasing to 123 knots at 125 m. Independent design considerations shall be for the value of each of the three types of icing below: (1) 75 mm glaze, specific gravity 0.9. (2) 150 mm hard rime, specific gravity 0.6. (3) 150 mm soft rime near the surface increasing linearly to 500 mm at 125 m, specific gravity 0.2. 20