Downloaded from https://www.everyspec.com MIL-HDBK-310 5.1.15 Hail Size. Hail is capable of causing considerable damage to military equipment depending on the stone's size, hardness, number density, and impact velocity. It generally occurs during thunderstorms. Despite the prevalence of thunderstorms in the humid tropics, hail is not as frequent in the low latitudes as it is in the mid-latitudes, except possibly in some tropical areas at high elevation. The principal zone of occurrence is between 30-50 ° N latitude.
Incomplete or inaccurate reporting of hail occurrences makes it difficult to state positively which section of this zone has the greatest frequency of hailstorms and the largest hailstone sizes. Some authorities cite north India as the area of most severe hail-storms. However, because of its long-term, high-quality records and its high frequency of very large hailstones, the Western Great Plains of the U.S. is selected as the most severe location for determination of design guidance. For this area, hailstone sizes were estimated from analyses of previous studies on hailstone sizes.
Since hail is a relatively infrequent climatic phenomenon and each occurrence is limited to a small area, the probability of a given site being hit by damaging hail is small. Considering the area of most severe conditions, observations indicate that Cheyenne, Wyoming, with over 9 occurrences per year, has the greatest average number of hailstorms annually. The most severe month at Cheyenne averages 2.9 occurrences, but a more representative worst- month average for the most severe area is assumed to be 2 storms. Individual hailstorms may deposit hail over an area ranging from about 10 km 2 up to a large strip as much as 50 km wide by 400 km long.
Coverage of the ground is not uniform, nor necessarily continuous. Hail from a single storm cell may have a duration of 10 to 15 minutes at any one site. A large storm may result from several cells each producing a hailstreak, which together comprise a hailswath. The largest hailstones in a storm tend to be near the center of a cell or along the axis of a hailstreak. In addition to hailstone size, two other characteristics of hail that have bearing on design considerations are density and terminal velocity. The density of hail-stones varies according to the relative proportions of rime and ice in the stone. The average density is near .8 gm/cm 3 (50 lbs/ft 3 ).
A value of .9 gm/cm 3 (56 lbs/ ft 3 ) is acceptable as an extreme for design calculations. The terminal velocity (w) of falling hailstones is directly proportional to the square root of the hailstone diameter (d) according to the formula w = K (d) 1/2 , where K is an empirically determined coefficient. For w in cm/sec, d in cm, K values at the surface ranging from 1150 to 1990 have been found. Maximum terminal velocities for large hailstones have been variously measured or estimated at 47 to 58 m/s. Fifty-eight m/s is acceptable as an extreme terminal velocity. 5.1.15.1 Largest Recorded.
A hailstone, irregular in shape, with a diameter of approximately 142 mm, fell at Coffeyville, Kansas, 3 September 1970. 5.1.15.2 Frequency of Occurrence. Hail occurs very infrequently, and design considerations should be based on the largest sizes expected to occur over many years. For general information, the estimated .001- and .01- percent hailstone diameters at the most severe location during the most severe month are approximately 50 mm and 20 mm, respectively. 5.1.15.3 Long-term Extremes. Hailstone sizes that would be expected to occur at least once in the most severe area during 10, 30, and 60 years of exposure are 70, 80, and 90 mm, respectively. 21